Honeywell alarm keypad fault codes1/21/2024 NOTE: Remember, there will be no ENTRY delay when arming with INSTANT or MAXIMUM.īefore arming your system, all protected doors, windows and other protection zones must be closed or BYPASSED, otherwise the keypad will display a “Not Ready” message, and if your keypad has a READY indicator light, it will not be lit. When arming AWAY or MAXIMUM, slow beeps will sound from the keypad (s) during the exit delay, turning to fast beeps during the final five seconds of the exit delay time. These modes can provide greater security while you are sleeping or while you are away for extended periods of time. You can also arm the system with no entry delay at all by using either INSTANT or MAXIMUM arming modes. The keypad will beep slowly during the entry delay period, reminding you to disarm the system. The system must be disarmed, however, before the entry delay period ends, or an alarm will occur. Entry delay gives you time to disarm the system when you re-enter the through the entry/exit door. When you arm your system, exit delay gives you time to leave through the entry/exit door without setting off an alarm. Your system has preset time delays, known as exit delay & entry delay. NOTE: The security code is always required, however, when disarming the system. If your system supports “Quick arming”, the key can be pressed in place of the security code when arming the system. Perimeter Armed with Exit Delay, NO Entry Delay Partial Zones programmed by Technician will arm with Entry/Exit Delay
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |